Xử lý xước nặng 800 – 1000

INTRODUCTION & FEATURES

Instruction

RECOMMENDED FORBody shops, used car dealers, detail shops and auto auctions. Designed for machine use to remove moderate to heavy oxidation & deep scratches on conventional acrylic enamel and lacquer paint systems and 800-1000 grit wet sand scratches, dust nibs, orange peel and other defects from fresh refinish paints of all types.APPLICATIONDirections: Shake well before using. NIOSH approved dust mask and safety glasses are recommended while using this product. For best results, do not apply in direct sunlight or onto a hot surface. Wash car to remove surface grime and dirt, then chamois dry. Start with a new PRO® VC-80-C Velcro™ Tufted Wool Buffing Pad. Used pads may contain contaminants which can scratch the surface. Use only as directed. Use with an electric or air buffer (1200-1700 rpm) coupled with a PRO® Wool Cutting Pad. Apply enough product to surface to work a small area (two to four square feet) and spread uniformly before buffing. Start machine and buff surface using adequate pressure. As product is used up and begins to dry, decrease pressure and burnish to a clean, glossy finish. Clean pad at regular intervals. Re-move any spatter from trim or moldings with a damp cloth.SPECIAL NOTESP-15 may also be used with the new high solid, low VOC basecoat/clearcoat refinish paints. These newer basecoat/ clearcoat finishes are much harder than pre-`93 refinish paints. Some newer factory applied finishes are also using this new clearcoat technology. Use caution in determining which type you are dealing with when using this product.

Viewed products